必赢56net在线登录
DongGuan cnauto automation equipment Co Ltd
总监在线
13713306830
news
position:home > news

Method for solving spray valve problem

writer:点胶设备 time:2019-10-16 10:18 clicks:
The problem of spray valve usually occurs after the closure of the glue valve. The 95% rule of the problem is caused by the diameter of the needle. The small needle will affect the flow and pressure of the liquid and cause back pressure, which will cause leakage shortly after the glue valve is closed. When the spray valve is used, the small needle will also affect the discharge of bubbles. This problem is solved by replacing the larger needle. The back pressure produced by the tapered needle is the smallest and the liquid flow is the smoothest. When the glue valve is closed, air in the liquid will leak. It is best to remove air from the liquid in advance, or use glue that is not easy to contain bubbles, or centrifugal and defoaming the glue before use.
 
 千分尺喷雾控制阀
Micrometer spray control valve
 
The inconsistency of glue delivery is mainly caused by the unstable air pressure and insufficient pressure in the pressure cylinder or storage liquid cylinder. The inlet pressure regulator should be set at 10-15 pounds/square inch lower than the factory minimum pressure. The pressure used in the pressure cylinder should be adjusted to the middle of the pressure regulator. The low pressure part of the pressure gauge should be avoided. The control pressure of the glue valve should be at least 60 pounds/square inch to ensure stable glue output. Finally, check the glue output time. If it is less than 15/1000 seconds, the glue output will be unstable, and the glue output time will become more stable until it reaches 30/1000 seconds.
 
Rotary spray valve
 
3. The flow rate is too slow. If the flow rate is too slow, the pipeline should be changed from 1 / 4 "to 3 / 8". If not necessary, the pipe should be as short as possible.
 
 旋转式喷雾阀
 
4. If the opening time of the valve is too short, the high fluid pressure caused by bubbles in the fluid may cause air infiltration into the liquid. The solution is to reduce the fluid pressure and use a tapered tip.
 
Spray out
 
 雾化喷射出胶
5. Instant dry glue (502) blocks the "joint" and pipeline of glue valve, mainly because the glue is reused when there is too much water or instant dry. Fresh instant dry glue shall be used. The glue pipe shall be thoroughly cleaned with acetone and shall not be damped. The air pressure used shall be completely dry. The filter shall be installed between the factory air pressure and glue valve system. (if the above method is still ineffective, nitrogen should be used
XML 地图 | Sitemap 地图